Stove Repair
Oakville

Gas burner won't ignite

"It clicks but won't light"

The most common stove call we get. Usually a clogged burner port blocked by spilled food or grease, a damaged spark electrode covered in residue, or a faulty igniter switch. Sometimes it's just a wet burner cap after recent cleaning.

We diagnose all four points on-site, clean clogged ports, and replace failed igniters with OEM parts.

Constant clicking but no flame

"It keeps clicking even when off"

Different from "won't ignite" — the spark works but no gas reaches the burner, OR the spark module fires continuously even when burners are off. Causes: a blocked gas valve, a moisture-soaked spark module, or a shorted spark switch stuck in the "on" position.

Continuous clicking is a fire hazard — gas can accumulate without ignition. We disconnect, dry, and replace failed components on the same visit.

Electric burner won't heat

"The element stays cold"

On coil stoves, usually a burnt-out heating element that needs replacement. On smooth-top glass cooktops: a failed radiant element underneath, a broken infinite switch that controls power, or a tripped 240V breaker leg on one phase.

We test elements with a multimeter, replace failed parts with OEM components, and verify proper heating cycles before leaving.

Yellow flame instead of blue

"The flame looks orange and lazy"

A yellow or orange flame means incomplete combustion — and it produces carbon monoxide. Causes: a misadjusted air-to-gas ratio, a partially blocked burner port, or improper gas pressure from a regulator issue.

Don't keep using the burner — CO is colorless and odorless. We recalibrate air shutters, clean ports, and verify proper blue flame on every burner before leaving.

Induction won't recognize pan

"Cookware error keeps showing"

Induction cooktops only work with magnetic cookware. The first check is always the pan — but if the issue persists with confirmed magnetic pans, it's usually a failed induction coil beneath that zone, a faulty cookware sensor, or a damaged power inverter board.

We diagnose Bosch, Miele, Wolf, and Thermador induction units — including the high-voltage inverter circuits most companies refuse to touch.

Knobs stuck or sticky

"Hard to turn, feels gritty"

Sticky or stuck knobs aren't just annoying — they often signal deeper problems. Causes: grease and food debris hardening behind the knob over years, a worn valve stem on gas models, or a cracked plastic insert losing its grip on the shaft.

Forcing stuck knobs can damage the underlying valve — a much more expensive fix. We clean, lubricate, or replace components before the damage spreads.

Smell of gas near stove

"Rotten egg smell when off"

A persistent gas smell when burners are off is an emergency. The source is usually a worn burner valve seal letting gas leak slowly, a loose gas line connection behind the unit, or a cracked supply hose on freestanding ranges.

Turn off the gas shutoff valve and call us immediately — we offer same-day emergency response. Never use the stove until it's been pressure-tested by a TSSA-certified technician.

Cracked glass cooktop

"There's a crack across the surface"

Glass cooktops can crack from dropped pans, thermal shock (cold liquid spilling on a hot surface), or heavy weight pressure on the edges. A crack isn't just cosmetic — it exposes electrical components underneath to spills and creates a safety hazard.

We replace cracked glass tops on all major brands and assess whether glass-only replacement makes financial sense versus a new cooktop.